Knowledge base

Get started with your Palworld server

Your Palworld server comes ready to start. Here is how you get it online, set passwords and get your friends in.

What you need

  • Your control panel login.
  • Palworld installed on your computer.
  • A server password for the players and an admin password for yourself.

1. Start the server

  1. Log in to the control panel and open your Palworld server.
  2. Press Start. The first start takes a few minutes while the world is created.
  3. Note the address and port in the panel. The game port is 8211 (UDP) by default. A separate query port (27015 by default, UDP) is only used to get the server shown in Steam's server list.

2. Settings in PalWorldSettings.ini

The server settings are in the file PalWorldSettings.ini. On Linux it sits under Pal/Saved/Config/LinuxServer/. Open it in the file manager. The folder only exists after the server has been started once.

Stop the server before you edit. Always edit the file while the server is stopped and start it again afterwards. Only edit PalWorldSettings.ini, not the default file DefaultPalWorldSettings.ini, which has no effect.

SettingWhat it does
ServerName / ServerDescriptionName and description the players see.
ServerPasswordThe password players need to get in.
AdminPasswordThe password you use for admin rights in the game.
ServerPlayerMaxNumMaximum number of players. 32 is the default and the ceiling.
RCONEnabled / RCONPortTurns remote control (RCON) on and sets the port.

3. Join the server

  1. Start Palworld and choose Join Multiplayer Game.
  2. Enter the server address and port (for example address:8211) at the bottom of the screen.
  3. Enter the server password and join.

The address and port for your own server are in the control panel.

4. Backup and RAM

World data and settings are in the Pal/Saved folder. Take a backup in the panel before you change settings or update.

Palworld can use a lot of RAM. A small group can manage on the smallest plan, but large bases and many Pals need more. Use the size guide to choose, and read how to add RAM.

Common problems

Players cannot join

Check that the server is running, that players use the right address and port (8211) and that the password is typed correctly. If you just started, wait until the console shows that the server is ready.

My changes have no effect

Did you change the default file, or change the file while the server was running? Edit PalWorldSettings.ini while the server is stopped and start it again.

The server gets slow or shuts down

That points to too little RAM for the number of players and bases. Add RAM or upgrade.

Read also

Need help?

If you get stuck, open a ticket and tell us which game, what you tried and what the console shows. We will help you from there.

Was the article helpful?